|
 CHATTANOOGA,
TENNESSEE — November 9, 2006. Heatec, Inc. has introduced a new line of
heaters trademarked FIRESTORM™. These heaters are designed
specifically to heat water used to make concrete. The heaters have an
extremely high thermal efficiency: up to 99 percent. They raise the
temperature of mix water up to 180 degrees F at flow rates from 20 to
300 gpm depending on the size of the heater. Unwanted atmospheric
emissions are almost non-existent.
Using heated water to make concrete enables ready-mix plants to extend
their working season, which would otherwise be limited by cold weather.
The heater heats mix-water as it is used to make the concrete. Because
it fully heats the water as it is pumped directly to mixing equipment,
only limited water storage may be needed for unusual demands.
The heater uses a fired burner. The burner fires into the side of the
heater shell (a vertical cylinder). Cold water is sprayed into the top
of the shell and migrates downward through diffusion material. The
water is heated by direct contact with the hot burner gasses as it
flows to the bottom of the shell where it accumulates momentarily. It
is pumped directly from the bottom of the shell to the concrete mixing
equipment.
The shell and other parts of the heater that are subject to corrosion
are made from stainless steel. Controls are automated using PLC
(Programmable Logic Controller) technology. A fully modulating burner
is used. The heater will be available in a variety of sizes.
The Firestorm line of heaters will have round-the-clock support by Heatec’s in-house parts and service departments.
One of the new heaters will be on display next January at the World of
Concrete Show in the Las Vegas Convention Center. Heatec will occupy
booth N309 in the North Hall of the convention center.
Heatec also makes water storage tanks for the concrete industry. The
tanks both heat and store the water. Heatec began operations in 1977
and is the leading manufacturer of heaters and storage tanks for the
hot mix asphalt industry. The company also makes heating and storage
equipment for the petro-chemical industry, the power generation
industry, the roofing industry and others. Heatec is a division of
Astec Industries.
You can find additional information about the new Heatec heaters and other Heatec products on the web at http://www.heatec.com
|
|
|
